Avonite Cut Outs<Back to Avonite
Cut-Outs for sinks and hobs are also available, at extra cost.
Hob cut-outs in particular must always be factory fabricated, as they must be set on an MDF sub-frame,which is set back, each corner strengthened and reflective insulation tape applied to all edges.
Pan Rests consist of 10mm bars placed in 5mm deep grooves in the worksurface. The bars are available in stainless steel or brass, in lengths of 200, 300 and 400mm lengths.
These are available as an extra over price quoted for six pan rests, but the customer can request more or less as required..
If you know what specification you require
then please complete the form below and
send us any drawings or a rough sketch to
assist us in our quotation to:
Free Site Survey
If you are not sure of the specification or
colour then please contact us for advice
and arrange for a free, no obligation on
site survey to help you with your project.
Telephone: (01977) 558 937
Lines available from:-
9.00am - 5.30pm Monday to Friday (excluding Public Holidays)